P831-LED
WARNING:
When using special control devices with this fixture, follow instructions carefully to ensure N.E.C. compliance. For
more help, contact a qualified electrical contractor.
WARNING:
To complete the installation, choose only UL listed Progress trims from the label inside the housing. The use of any
trim not listed in this fixture is a violation of N.E.C. article 110-3(B) and voids all warranties.
WARNING:
Thermal insulation may be installed in direct contact with the fixture, but DO NOT install insulation in excess of eight
inches deep above fixture. Greater depth may cause the thermal protector to cycle the fixture on and off.
WARNING:
National Electrical Code, Article 110-3 (b), states that “Listed or labeled equipment shall be used or installed in
accordance with any instructions included in the listing or labeling”. Use only Prescolite UL listed trims. Use of other trims not
listed in this fixture, including those that are UL classified, is a violation of N.E.C. 110-3 (b) and voids all warranties.
1. For Wooden Joists: Extend the Bar Hangers (6), use joist alignment tabs (4) to locate fixture and position underneath support
joist (8). Drive the 4 Nails (7) into Joists (8) (Fig. 2). Drive additional nails through holes in Bar Hanger for alternate support if
required.
2. For Suspended Ceilings: Place the Fixture on the ceiling grid with the "T" Bars (9) running through the Bar Hanger Notches
(10). Using a flat head screwdriver or other tool, bend the integral t-bar mounting tabs (11) downward to a vertical position (Fig.
3). Secure housing to the support structure with tie wire (supplied by others) in the holes supplied. Sheetmetal screws (supplied
by others) can also be used in the holes supplied (20).
3. Locate Housing along Bar Hanger in desired position and, using pliers, squeeze the 4 Locking Tabs (12) on the Plaster Frame
(13) tightly over the Bar Hangers to prevent further Housing movement. Screws (1) are provided that can be tightened to lock
Housing on the Hanger Bars.
4. As desired, hanger bars (6) may be shortened at score mark to fit tight mounting conditions and joist alignment tabs removed
to adjust vertically as needed by breaking off with pliers.
5. Unsnap Junction Box Cover (14) by lifting the Leaf Spring (24).
6. Run supply wires through UL Listed connectors (not supplied) in one of the five Pryouts (15) on the Junction Box (16) or Type
NM cable (ROMEX) through an Opening above the Wire Retaining Plate (17). Connect Supply Wires (19) as shown in Fig 4 & 5.
Replace Cover.
7. FOR AIR-TIGHT APPLICATIONS: This Progress product is Air-Tight approved per ASTM E283 testing standards and
complies with Washington State Energy Code Requirements. To complete the installation of this Air-Tight product, the opening
between the housing (3) and drywall ceiling (22) must be sealed by the installer using silicone caulking, tape, or any other
means acceptable to the local codes official. Progress Lighting Gasket Kit P8588-01 (purchased separately) can be used for this
purpose (Fig. 6).
8. Select a Trim from the Wattage Label inside the Housing. Use Only Lamp Types approved for the Trim chosen.
DO NOT
EXCEED MAXIMUM LISTED WATTAGE(S)
! For trim installation, refer to trim installation instructions.
9. To gain access to junction box (16) after ceiling is finished, twist Housing (3) out of Plaster Frame (13). Remove screw (2) and
access door (5) inside of fixture. Junction box cover plate (14) can now be removed for service (Fig. 6).
INSTRUCTION SHEET MUST BE REMOVED FROM FIXTURE PRIOR TO ENERGIZING.
