6
4.
Note that there is still a plastic tie in the Right
Handrail (85); do not remove this plastic tie.
Position the Right Handrail (85) on the right Upright (82)
as shown. The bracket on the base of the right Upright
should be
inside
of the lower end of the right Handrail, as
shown in the inset drawing.
While holding the Console Base (87) near the Right
Handrail (85), feed the Console Wire Harness (48) into
the Right Handrail. Next, place the Console Base on the
Handrails (74, 85). Insert any remaining Console Wire
Harness into the Right Handrail.
Thread two Handrail Bolts (78) with Handrail Washers
(96) into the Left Handrail (74) and the left Upright (82) as
shown.
Do not tighten the Handrail Bolts yet.
Next,
thread two Handrail Bolts (78) with Handrail Washers
(96) into the Right Handrail (85) and the right Upright
(82).
Do not tighten the Handrail Bolts yet. Be careful
to avoid damaging the Console Wire Harness (48).
74
78
48
Do not
Remove
this
Plastic
Tie
82
82
78
96
96
87
96
85
4
Bracket
74
5. Attach the Console Base (87) to the Left and Right
Handrails (74, 85) with four Long Screws (93).
Refer to assembly step 4. Tighten the four Handrail
Bolts (78) used in assembly step 4.
85
74
93
93
5
87
82
79
6. Press two Small Upright Plugs (79) into the holes near
the upper ends of the Uprights (82).
6
100
99
82
7. Remove the backing from the Adhesive Clip (99). Press
the Adhesive Clip onto the base of the right Upright (82)
as shown. Press the Allen Wrench (100) into the
Adhesive Clip.
8.
Make sure that all parts are tightened before you use the treadmill.
To protect the floor or carpet, place a
mat under the treadmill.
7
78
