-1-
This hard disk drive unit is made by Pro-face for use with its panel-type computers,
hereafter referred to as the "PL". This 2.5 inch 40GB hard disk is designed to be in-
stalled inside the PL.
PL-HD240
Installation Guide
Corresponding PL units: PL-X930 Series units
(All product names that appear in this guide are the trademarks of their re-
spective companies)
Pro-face: Digital Electronics Corporation (in Japan and other countries)
MS-DOS, Windows: Microsoft Corporation (USA)
To Prevent Accidents
• Since the PL-HD240 is a precision instrument, be sure it is neither hit by nor pressed
strongly against another object. After unpacking, be sure the unit is not dropped or
jolted during installation. Also, a PL built in to a larger unit (i.e. operation panel)
should be removed and packed separately prior to shipping.
• Be sure water, liquids or metal particles are not allowed to enter the PL-HD240. Any
of these may cause either a breakdown or an electrical shock.
• Do not place or store this unit in a location where there is direct sunlight, excessive
heat, dust or vibration.
• Do not store or operate this unit near chemicals, or where there are chemical fumes.
• Do not allow anyone other than Pro-face’s own service staff to perform mainte-
nance or adjustments to this unit.
• Do not move or shift the PL while the PL-HD240 is installed and the PL unit's power
is ON.
• Be sure to check that the PL’s power is disconnected before
installing the unit, in order to prevent an electrical shock.
• Do not attempt to modify or open the PL-HD240, since it can
cause a shock or fire.
• When installing the PL-HD240, be sure to read the following “3.
Installation” section’s information completely to insure that the
unit is correctly installed.
WARNINGS
WARNINGS
