All appropriate safety equipment and gear must be used during the installation of this or any ProCycle product including any
time you work on a vehicle. ProCycle accepts no responsibility for injuries or damage incurred during the installation of any products.
4. Remove the wing nut and the metal washer from the lower cap bolt and then place the spacer
on the bolt (be sure the plastic washer is between the cap and spacer). Place the bolt through
the bracket, place the metal washer and wing nut on the bolt. Just start the wing nut with a few
turns, do not tighten yet. See image below for exact order of hardware. Sometimes the Plug
manufacturer does not include the Plastic Washer, it is not necessary.
5. Place the PVC tube over the lower cap and tighten the wing nut.
6. Slide the supplied clamp over the PVC tube and place the 8x16mm bolt through the bracket
and into the threaded bracket on the frame that held the helmet lock and tighten.
7. Place your tools in your new tube and insert end cap.
8. Congratulations! You now have the biggest Tool Tube available for your WR.
