ProCurve 3500yl Series, Руководство по управлению и настройке, Страница: 653 / 732

C-45
Troubleshooting
Debug/Syslog Operation
The severity levels in order from the highest to lowest severity are: major,
error, warning, info, debug. For a list of valid values for the
logging system-
module < system-module >
command
,
refer to Table C-1 on page C-28
.
5. If you configure system-module and/or severity-level values to filter Event
Log messages, when you finish troubleshooting, you may want to reset
these values to their default settings so that the switch sends all Event Log
messages to configured debug destinations (Syslog servers and/or CLI
session).
To remove a configured setting and restore the default values that send
all Event Log messages, enter one or both of the following commands:
ProCurve(config)# no logging severity
< debug | major | error | warning | info>
ProCurve(config)# no logging system-module
< system-module >
C a u t i o n
If you configure a severity-level, system-module, logging destination, or
logging facility value and save the settings to the startup configuration (for
example, by entering the
write memory command), the debug settings are
saved after a system reboot (power cycle or reboot) and re-activated on the
switch. As a result, after switch startup, one of the following situations may
occur:
■ Only a partial set of Event Log messages may be sent to configured debug
destinations.
■
Messages may be sent to a previously configured Syslog server used in an
earlier debugging session.
Displaying a Debug/Syslog Configuration
Use the
show debug
command to display the currently configured settings for:
■
Debug message types and Event Log message filters (severity level and
system module) sent to debug destinations
■ Debug destinations (Syslog servers or CLI session) and Syslog server
facility to be used
Syntax: show debug
Displays the currently configured debug logging destinations
and message types selected for debugging purposes. (If no
Syslog server address is configured with the
logging
<
syslog-ip-
addr
>
command, no show debug command output is displayed.)
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 45 Monday, January 28, 2008 10:04 AM