ProCurve 3500yl Series, Руководство по управлению и настройке, Страница: 519 / 732

A-31
File Transfers
Transferring ACL Command Files
USB: Uploading an ACL Command File from a USB Device
For example, suppose you:
1. Created an ACL command file named
vlan10_in.txt
to update an existing
ACL.
2. Copied the file to a USB flash drive.
Using a PC workstation, you then execute the following from the CLI to upload
the file to the switch and implement the ACL commands it contains:
ProCurve(config)# copy usb command-file vlan10_in.txt pc
Uses Xmodem to copy and executes an ACL command from a
PC or Unix workstation. Depending on the ACL commands
used, this action does one of the following in the running-
config file:
■ Creates a new ACL.
■ Replaces an existing ACL. (Refer to “Creating an ACL
Offline” in the “Access Control Lists (ACLs)” chapter in
the latest
Access Security Guide
for your switch.)
■ Adds to an existing ACL.
Syntax:
copy usb command-file < filename. txt > < unix | pc >
where:
< filename.txt > = A text file containing ACL commands
and stored in the USB flash drive.
< unix | pc > = The type of workstation used to create the
text file.
This command copies and executes the named text file from a
USB flash drive and executes the ACL commands in the file.
Depending on the ACL commands used, this action does one
of the following in the running-config file:
■ Creates a new ACL.
■ Replaces an existing ACL. (Refer to “Creating an ACL
Offline” in the “Access Control Lists (ACLs)” chapter in
the latest
Access Security Guide for your switch.)
■ Adds to an existing ACL.
3500-5400-6200-8200-MCG-Jan08-K_13_01.book Page 31 Monday, January 28, 2008 10:04 AM