Procon V3D Series, Руководство программиста

Страница: 14 / 88

H - I - J
PROGRAMMER’S MANUAL
V8.94.11-
- 14 -
Information about the program versions
Due to our continuous program developing and our efforts to meet our customers’ demands
we reserve our rights to alter the program!
The program versions are indicated in b
oth the Programmer’s Manual and the
11 System menu of the frequency
converter (e g. 8.94.11)
In order to maintain compatibility, please note following about the meaning of the version number:
•
The first two numbers refer to the system processor.
•
With identical first figures, the frequency converters are fully compatible. (they work similarly, they can be
replaced by each other, and if necessary, they can be connected to each other)
•
With increasing values of the second number, the capabilities of the given program are wider.
•
The third number refers to the peripheral processor.
8
CAUTION
Always use the manual with the same version number as that of the frequency converter!
In any uncleared question contact the manufacturer!
Information on program update
•
The manufacturer provides all users with the latest program version free of charge, but they have to bring the
frequency converter to the manufacturer’s premises! The new program is downloaded while you wait!
•
The user can request program upgrading on the site of the frequency converter to avoid interruption of the
production procedure (or for other reasons).
The program upgrading is free of charge in this case, too. The user has to bear the costs of the field-work only!
Procedure of programming
After defining the objective, programming should be started as follows.
OPERATION MODE
Control
(factory setting)
Regulation
Select the
reference signal source
(e.g. An. IN1)
Select the
source of the logic controls
(e.g. start, direction)
Setting the
start / stop parameters
(e.g. Tup, Tdown, etc.)
Setting the
motor parameters
(e.g. Pn, Un, In, etc.)
Setting
other parameters
(e.g. display, etc.)
Select the
reference signal source
Suggested saving
(e.g. Memory 1, Terminal 1, etc.)
Select the
feedback signal source
Setting the
regulation parameters
Select the
source of the logic controls
Setting the
start / stop parameters
Setting the
motor parameters
Setting
other parameters
Suggested saving