Item No. 747102 - Vehicle Cradle - Spring Lock,
USB Port and Hard-Wired Power
Compatible with:
Panasonic FZ-L1
Important:
Self-installation instructions and advice are provided for your
convenience. It is your responsibility to determine if you have the
knowledge, skills, and physical ability required to properly perform an
installation. ProClip USA, Inc. shall have no liability for damage or
injury resulting from the installation or use of any ProClip or third
party products. It is your responsibility to ensure that all products are
installed in adherence with local laws and regulations and in such a
manner as to allow a vehicle to be operated safely and without
distraction. ProClip USA, Inc. product warranties do not cover the
installation, removal or reinstallation of any product.
Power Rating:Input Voltage: 10-30 VDC, 1A Output Voltage: 5 VDC, 3A
Wiring: Follow the diagram below. Route the wire from the holder behind the dashboard and connect it to a
power source; White or Black to ground or the vehicle chassis, and Red via the 2A in-line fuse to a positive power
source. Professional installation is recommended.
Attention: Carefully read all instructions and review the images before installing this product.
1. USB Type-A Host Port
The cradle includes a USB port for attaching scanners, printers and sensors.
This port is connected to the device using the docking connector and does not
occupy the USB Type-C port.
Connect the USB cable and secure it using the included retention clip and Allen
wrench.
3. Inserting the Tablet
Align the bottom of the tablet with the docking connector for the tablet. Allow
the tablet to seat to the bottom of the cradle before pressing the top of the
tablet to snap the top support into place.
Slide they spring lock down over the tablet and to lock the tablet into the cradle.
2. Mounting the Cradle
Remove the screw in the center to release the tilt-swivel plate from the cradle.
Using the pre-drilled holes and included fasteners, attach the tilt-swivel plate to any
AMPs compatible mount, pedestal, or flat surface. (Pedestal not included).
Re-attach the cradle with the center screw. Leave the screw slightly loose to allow
adjustments or fully tighten to lock to the desired angle.
4. Enable Dock Settings
For correct operation while docked, the following settings need to be set on the FZ-L1.
Open Settings, then Connected Devices and then External Device. Scroll to the
Cradle Settings and then enable the first 4 options:
Suspend when Docked in cradle
USB selective suspend
Device without DC input
Power supply
