Item No. 539893 - Charging Cradle with Key Lock
and USB for Expansion Back
Compatible with:
Zebra ET50 8.3 | Zebra ET55 8.3
For Device with Rugged Frame and Expansion Back
Important:
Self-installation instructions and advice are provided for your
convenience. It is your responsibility to determine if you have the
knowledge, skills, and physical ability required to properly perform an
installation. ProClip USA, Inc. shall have no liability for damage or
injury resulting from the installation or use of any ProClip or third
party products. It is your responsibility to ensure that all products are
installed in adherence with local laws and regulations and in such a
manner as to allow a vehicle to be operated safely and without
distraction. ProClip USA, Inc. product warranties do not cover the
installation, removal or re-installation of any product.
Attention: Carefully read all instructions and review the images before installing this product.
1. Attach the cradle to the mounting position using the applicable bolts
enclosed. Cradle can be attached to any mount that uses the AMPS or VESA
75 hole patterns. The enclosed cable clamp can be attached to the strain-relief
tab with two enclosed screws to keep the power cord in place and prevent
damage from stress.
3. To remove the tablet from the cradle: Open the lock using enclosed key and
slide the block up. Press upwards on the upper part of the cradle, in the same
time pull the upper part of the device out from the cradle and then lift the device
up and out from the cradle.
2. To place the device in the cradle: Place the lower part of the device in the cradle,
then flip/press the upper part forwards so it snaps into place in the cradle. Secure the
lock with one of the enclosed keys.
4. The cradle and tablet are in place.
