Proceq SA
Ringstrasse 2
CH-8603 Schwerzenbach
Switzerland
Phone
+41 43 355 38 00
Fax
+41 43 355 38 12
last update: 30.07.2014
page 12
4.
Quick guide
4.1
Important remarks
for the first time, you need to have read and understood at least
the chapter 2
“Safety precautions and warning” as from page 7 of the instruction manual. This
quick guide only explains the most basic functions/operation steps. Some of the features shown
on the model may be optional at extra cost.
4.2
On/Off
Before you take out the instrument from the transportation carrying case, turn on the unit by
shortly pressing the on/off button
. Before the display changes to the measure mode, you
will see shortly the logo of the manufacturer on a white background. For further information
please refer to chapter 6
„Setting up“ as from page 16.
4.3
Calibrate
If the instrument indicates that the calibration is outdated, or if it is required by the applicable
has to be calibrated. Press the symbol
and
to open the
calibration function. In the standard setting there are listed night visibility R
L
and day visibility Qd
to be calibrated on the calibration standard. Take care that the
the included calibration standard. Otherwise, the
will give you an error message.
By pressing
you trigger the calibration. After the calibration you get a message that
the calibration was successful or you get a remark of the deviation. With
you confirm
the calibration and you get back to the measure mode. For further information please refer to
chapter 8
„Calibrate“ as from page 17.
4.4
Measure mode
For the correct positioning please refer to chapter 9
By pressing the measuring button
the reading is started. During the measuring period
which is about 2-
3 seconds, you will see „-„ on the top line and the symbol
on the top left
side. After a successful reading, the measurement values will be shown on the top. If you take
further measurements, the last measurement value is always shown in the second line on the
top. For further information on the measure mode, please refer to chapter 9
„Measure” on page
24. For changing the settings of the measure mode, please refer to chapter 14.3
“ as from page 47. By pressing the measuring button you get back to the measure mode
from each function.
