Probuilder 54865, Инструкция по эксплуатации, Страница: 26 / 65

26
Assembly and cleaning
Assembly
Connect regulator (6) to lid (8).
Screw handle (3) into its threaded socket in
middle of lid, tighten nut.
Connect air hose from air supply to one of
the connectors (4), and connect air hose (9)
between the other connector and that (12)
on the spray gun (16).
Connect paint hose (11) between connector
on lid (1) and that on spray gun (17).
Filling with paint
Check the paint is fully mixed and no skin
has formed. Filter if required before � lling to
remove skin, particles etc.
Check tank is not under pressure, slacken
the four clamps (2), and remove lid.
Pour pain into tank (10). If paint comes in
a can that � ts into tank, it can be inserted
into the tank instead. Check that pipe on
underside of lid reaches down into the can!
Fit lid and tighten clamps. Check lid � ts
tightly.
Use
Before use, � t a quick coupling for air supply
(not included) and � t a 3/8” compressed air
hose on the manometer (4).
A water and oil separator (not included)
should be � tted before use for optimal
results.
Connecting air supply
Close regulator fully by turning
anticlockwise.
Set supply pressure (max. 80 PSI) on air
supply and switch on.
Setting pressure
Set desired working pressure for spray gun
by turning regulator clockwise.
Pressure can be checked on the manometer
(4). Working pressure should normally be
25-30 PSI but can be higher for use of spray
guns with internal mixing of paint and air,
or if the gun is used at high elevation above
the tank.
Working pressure can be adjusted by
turning regulator. It is not necessary to stop
working and bleed the system before doing
so.
Using the spray gun
Turn the compressed air regulator
(14) clockwise to reduce pressure and
anticlockwise to increase.
Turn the nozzle regulator (15) clockwise to
spray in a jet and anticlockwise to spray in a
fan shape.
Hold the gun perpendicular to the wall at a
distance of 20 cm.
Press and hold trigger (13). Paint will spray
from the nozzle.
Move the gun evenly from side to side, and
allow each stroke to overlap by approx.
50%.
Allow layers to dry before adding another
coat.
Release trigger when � nished painting.