5
Locate the top rigging line that is marked "D." Carefully unwrap
the line. After feeding the rigging line into the spreader
proceed to the eyelet labeled “D” and clip into the eyelet
(refer to photo 16).
Locate the lower rigging line just below the spreader marked "D."
Carefully unwrap the rigging line.
Clip the rigging line into the eyelet marked "D" as shown. At
the end of this step, both rigging lines that were marked "D"
will be clipped to the above eyelet marked "D."
Locate the jib stay on the rigging line and pull up carefully on
the jib stay to adjust the tension slightly taught as shown.
Again, there should be no slack but the mast should remain
completely vertical.
Locate the rigging line at the top of the mast marked "E."
Carefully unwrap the line.
Proceed directly to the eye plate on the rear of the hull
marked "E." Clip the rigging line as shown.
Section 2—Completing the Boat (continued)
14
15
16
17
18
19
Spreader
