4
Locate the jib sail boom. It will have a "B" sticker on one end.
Find the rig line from the jib sail that is marked "B". Remove
the tape from the line and insert it through the eyelet.
After pulling the rig line through the eyelet, make certain that
the space between the bottom of the sail and the sail boom is
approximately
1
/
2
" to 1" (see photo 23). Now, tie a secure
knot in the line.
Locate the jib stay on the rigging line. Pull up carefully on the
jib stay to adjust the tension as shown until there is no slack
in the line, but the mast is still completely vertical.
Carefully unwrap the top rigging line that is marked "C."
Insert the line into the spreader as shown.
Note:
The spreader has a small factory made slot in the outer
hole. The inner hole will not be used. This makes it much
easier to insert the line into. You can simply push the rigging
line through the slot.
After feeding the rigging line through the spreader, open the
rigging clip and attach it into the eye plate marked "C." Close
the wire clip. Repeat this step with the lower rigging line
that is marked "C." This lower rigging line is located directly
below the black spreader, and it will also clip to the eye plate
that is labeled "C." When you have completed this step, both
rigging lines marked "C" will be clipped to the eyelet marked "C."
Section 2—Completing the Boat (continued)
Lower
Rigging
Line
7
8
9
10
11
12
13
