Usage instructions BUDDY 4all & classic
24
Figure 39: Clothing guard mounted on product (view
without drive wheel)
Figure 40: "Side section mount, bolted" (view with-
out clothing guard)
20.2.2 Removal and attachment of the
clothing guard
To
remove the clothing guard
, it is first pulled
from the "side section mount, bolted" at the
front and then from the back joint shaft at the
rear.
Figure 41: Clothing guard pulled from the "side
section mount, bolted" at the front (view without
drive wheel)
To
attach the clothing guard
, this is first
mounted on the back jointed shaft with the rear
side section mount and then the front side
section mount is inserted in the "side section
mount, bolted".
Figure 42: Rear side section mount mounted on
back joint shaft (view without drive wheel)
20.2.3 Adjusting the clothing guard
position
The following instructions are intended
for and may only be carried out by a rehabilita-
tion specialist dealer or PRO ACTIV
After adjusting the drive wheel position or in-
stalling different tyres on the drive wheels, it
may be necessary to adjust the position of the
clothing guard on the wheel arch. The distance
between the tyres and the clothing guard
should be between 5 and 8 mm to avoid pinch-
ing your fingers, scraping the tyres on the
clothing guard, and obstruction when grasping
the handrim.
To adjust the clothing guard position, loosen
the four M5 fixing screws (AF 3 mm) from the
clothing guard mount on each of the clothing
protection guards.
Back jointed shaft
Side section
mount, bolted
Side section mount, bolted
