V1.0
8688822
Please read and understand all instructions before use. Retain this manual for future reference.
SPECIFICATIONS
Rated Input Flow
10 GPM
Maximum Pressure
3,000 PSI
Internal Leakage
5 cu. in./min. @ 3,000
PSI
Filtration
Requirement
10 Micron minimum
Temperature Range
-30°C to 120°C
(-22°F to 250°F)
Power Consumption
20W (1.7 A)
Port Size
8 ORB
INTRODUCTION
This valve is used to turn the hydraulic oil flow
OFF or ON within the hydraulic system. The
valve is closed and both ports are blocked
when there is no power to the coil. The valve is
open and allows flow in either direction when
the coil is powered.
SAFETY
WARNING! Read and understand all
instructions before using this device. The
operator must follow basic precautions to
reduce the risk of personal injury and/or
damage to the equipment.
Keep this manual for safety warnings,
precautions, operating or inspection and
maintenance instructions.
1.
Use the correct device for the job. This
device was designed for a specific function.
Do not modify or alter this device or use it
for an unintended purpose.
2. Operate in a safe work environment. Keep
your work area clean, well-lit and free of
distractions.
3. Do not operate any device when tired or
under the influence of drugs, alcohol or
medications.
4. Always wear impact safety goggles that
provide front and side protection for the eyes.
Eye protection equipment should comply
with CSA Z94.3-07 or ANSI Z87.1 standards
based on the type of work performed.
5. Wear protective clothing designed for the
work environment and device.
UNPACKING
WARNING! Do not operate the device if any
part is missing. Replace the missing part before
operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the
packaging and inspect for damage. Make sure
that all items in the parts list are included.
Contents:
•
Solenoid Valve
ASSEMBLY &
INSTALLATION
WIRING
1.
Connect positive wire (+)
to terminal 1.
2. Connect negative wire (-)
to terminal 2.
OPERATION
Apply power to the
solenoid to open the valve
and allow hydraulic oil to
flow. Stop supplying power
to the valve to cut off the
flow of oil.
12V DC 2-WAY, 2-POSITION
NORMALLY CLOSED DIRECTIONAL CONTROL VALVE
