Pro-Line Boats 2010 26 Express, Руководство пользователя

Страница: 20 / 55

14
Systems and Accessories
Electrical System
12 Volt Receptacle
The 12-volt receptacle is installed on the console. It is easily accessible and can be used to charge your cell
phone, operate a hand held remote spotlight, etc.
Air Conditioner (Optional)
The installation of the air conditioner system included the following components:

Control knobs (mode and thermostat) are installed on the aft wall of the cabin.

Air conditioning vent is installed on the aft wall of the cabin.

Air conditioner return is installed next to the step on the aft wall of the cabin.

Air conditioner unit is installed behind the air conditioner return.

Water pump and seacock are installed below the cabin floor and are accessible via the round
access pie next to the cabin step.

On/Off battery switch is installed behind the hatch that is located next to the fire extinguisher
holder.

Shore power inlet is installed in the port aft corner of the cockpit, above the raw water washdown
outlet.

Battery charger installed in the aft bilge.
Air conditioner return Air conditioning vent
(air supply grille)
Control knobs
To operate the air conditioner unit:

Ensure that the seacock (seawater intake ball valve) is open. The seacock is open when the
seacock lever is in the horizontal position.

Turn the mode control knob to off.

Turn on the air conditioning unit circuit breaker.

Turn the mode control knob to fan. This energizes the fan.

Turn the thermostat control knob to the coolest position by rotating it fully clockwise.

Verify that the fan is running and that there is steady airflow out of the air conditioning vent.

Turn the mode control knob to run. This will start the compressor and seawater pump.

Check for a steady solid stream of seawater from the overboard discharge (thru hull).

To set the thermostat, allow sufficient time for the unit to cool the area to the desired temperature.
When the area is sufficiently cooled, turn the thermostat knob slowly toward the center position
until it clicks once. The thermostat is now set to maintain a constant temperature.
Caution: Do not turn the unit off and immediately turn it back on. Wait at least 2 minutes for the
system refrigerant pressures to balance.
Mode
Thermostat