Pro-Form Perspective 1000, Руководство пользователя

Страница: 23 / 32

23
Inspect and tighten all parts of the elliptical exerciser
regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and
a small amount of mild soap. Make sure to regularly
clean the rollers and the track on which the rollers
ride.
Important: To avoid damage to the console,
keep liquids away from the console and keep the
console out of direct sunlight.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the console does not display your heart rate when
you hold the handgrip pulse sensor, or if the displayed
heart rate appears to be too high or too low, see step
5 on page 16.
HOW TO LEVEL THE ELLIPTICAL EXERCISER
If the elliptical exerciser rocks slightly on your floor
during use, see HOW TO LEVEL THE ELLIPTICAL
EXERCISER on page 13.
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest setting, the
drive belt may need to be adjusted. To adjust the
drive belt, first remove the screws from the left and
right side shields (not shown). Note: There are two
different sizes of screws in the side shields; be sure to
note the location of each screw. Then, gently pull the
side shields apart and remove the convenience tray.
Next, locate the Idler Screw (68) and loosen it one
half turn. Step onto the elliptical exerciser and move
the pedals. If the pedals continue to slip, turn the Idler
Screw another half turn and test the pedals again.
Continue in this way until the pedals no longer slip.
Then, replace the convenience tray and reattach the
side shields.
MAINTENANCE AND TROUBLESHOOTING
68