7
3
3. Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into one end of
the Incline Axle (13). Apply a small amount of grease
to the Incline Axle.
Raise the Ramp (3). Insert the Incline Axle (13) into
the welded tube under one side of the Ramp, through
the motor screw, and then into the welded tube under
the other side of the Ramp.
As you insert the Incline
Axle through the motor screw, make sure that the
motor screw does not turn.
Slide an M6 Washer (64) onto an M6 x 16mm Patch
Screw (76). Tighten the Patch Screw into the open
end of the Incline Axle (13).
13
Grease
Motor
Screw
64
76
3
64
76
4. Have another person hold the Upright (2) in the posi-
tion shown.
Connect the Upper Wire Harness (115) to the Lower
Wire Harness (42). Insert the connectors on the Wire
Harnesses up into the Upright (2).
Carefully pull the
upper end of the Upper Wire Harness to remove
the slack from the Wire Harnesses.
See the inset
drawing. Attach the Lower Wire Harness to the
Upright with the Nylon Zip Tie (129). Pull the Nylon
Zip Tie tight and cut off the excess.
Insert the Upright (2) into the Frame (1).
Be careful to
avoid pinching the Wire Harnesses (115, 42).
Attach
the Upright with two M10 x 108mm Button Screws
(70), two M10 Split Washers (73), and two 7.6mm
Spacers (109);
make sure that the curved sides of
the Spacers are facing the Upright. Be careful to
avoid damaging the Wire Harnesses with the
Button Screws.
2
115
70
42
1
73
73
109
4
109
Do not pinch the
wire harnesses
during this step
1
42
2
129
