Assembly
When using the Treadmill for the first time you may find the Belt (9) moves to one
side. This can be easily overcome using the Belt Adjustment Bolts located at the
rear of the Base Frame.
If the Belt runs to the right you will need to adjust the Adjustment Bolt on the
Right Rear Base Frame by turning it half a turn (Clockwise) using Allen Bolt Driver (I)
(Supplied). Test the Belt for 1-2 minutes, if it still runs to the right then try
another half turn. If after a further 1-2 minutes the Belt is still not running
centrally do not tighten the right bolt again. Adjust the Adjustment Bolt on the
Left Rear Base Frame one half a turn (Counter Clockwise) Now test it again for 1-2
minutes.
ADJUSTING THE BELT TRACKING
If the Belt is too loose tighten (Clockwise) both Adjustment Bolts one half a turn
each. If it is still too loose, then turn (Clockwise) both Bolts one half a turn again.
TENSION
9
10L
I
Page 16
Folding Manual Treadmill
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
