Pro-face Xycom 3015, Руководство по оборудованию

Страница: 25 / 44

3 Operator Input
Xycom Automation offers models with different integrated operator input options.
These options are designated by the model numbers as follows:
(no designation)
No Keypad, no touchscreen
T
Touchscreen (no keypad)
This chapter includes information about the possible operator input options of your unit.
TOUCHSCREEN
Xycom Automation's touchscreen complies with environmental specifications and
maintains a NEMA 4 seal when panel-mounted. It remains operational even after 30
million touches. Installation and configuration requirements vary according to the op-
erating system in use. If you change the operating system, you must install and config-
ure the corresponding touchscreen driver software.
Installing Touchscreen Drivers
If your system has a touchscreen controller you must determine which driver(s) to
install.
Power up the system to see what response the Input LED gives. You must watch closely
for the Input LED response during power up to see the response. If the LED flashes
three times at power up it has a Xycom touchscreen controller. After flashing three
times the LED will be constantly and dimly lit. However, if at power up the LED is con-
stantly and dimly lit (with no flashing) your system has a Microtouch touchscreen
controller.
You will install the driver that corresponds to the touchscreen controller and the oper-
ating system of the host computer.
1. Insert the
Documentation and Support Library CD in the CD-ROM.
2. Navigate to the Drivers/Touchscreen folder.
3. Inside that folder are other folders with the titles of various drivers. Refer to the fol-
lowing matrix to determine which driver(s) you need for your system.
21