Pro-face PS-3700A, Руководство пользователя, Страница: 39 / 131

Compact Panel Computer PS-3700A (Pentium
®
4M - 1.7GHz Model) User Manual
2-12
2.2.2 Installation Procedures
Follow the steps given below when installing the PS-A.
„
Attaching the Installation Gasket
Even if the your PS-A’s Installation Gasket is not needed to prevent water from entering the unit, the gasket
also acts as a vibration absorber and should always be attached. To install it, place the PS-A face down on a
soft surface and attach the gasket to the rear side of the display face, in the plastic bezel’s groove (see picture
below).
• Before mounting the PS-A into a cabinet or panel, check that the installation gas-
ket is attached to the unit.
• A gasket which has been used for a long period of time may be scratched or dirty,
and may have lost much of its water resistance. Be sure to change the gasket at
least once a year, or when scratches or dirt become visible.
• The corresponding gasket is CA3-WPG15-01.
• Since the gasket is flexible but not elastic, be careful not to stretch it unnecessar-
ily, as doing so could tear the gasket.
• Be sure, when pushing the gasket into the installation groove and around the cor-
ners of the PS-A, that the gasket’s seam is not placed in a corner. Placing the
seam here could eventually cause the gasket to tear
• Be sure to place the gasket’s flat, non-grooved side facing down.
• If the installation gasket is not properly inserted into the groove, the gasket’s
moisture resistance may not be equivalent to IP65f.
• When the installation gasket is properly inserted, approximately 2.0 mm of it will
extend outside the groove. Before installing a PS-A into a panel, be sure to con-
firm that the gasket is correctly in place.
Gasket seam
PS-A Rear Face
Gasket
Installation
Groove