Pro-face PL-6930-T41, Руководство пользователя

Страница: 56 / 175

Chapter 3 Peripheral Device Installation
3-5
(4) Lift up slightly the hooks of the half cover and remove it from the unit.
3.1.2 Installing the Main Memory
(1) Uninstall the rear maintenance cover and the half cover.
(2) Install the main memory shown as the following figures. Put the DIM module in the connector at a tilt
then push it all the way. Next, push it down until it can engage tightly with the stopper.
(3) Return both of the rear maintenance cover and half cover to the unit. Screw the screws to install them on
the unit. The requirement torque force is 0.5N•m to 0.6N•m.
• Since DIM module sockets are easy to break, be sure to install the DIM module
• very carefully.
SEE
3.1.1 Uninstalling the Rear Maintenance Cover (page3-2)
DIM module
1
2
Connector
Stopper
Main Memory