Pro-face FP5000 Series, Руководство пользователя, Страница: 70 / 95

Installation and Wiring
70
Front USB Cover
Section 6.4
Front USB Cover
Opening the Front USB Cover
When using a factory-installed front USB cover (without screw), the front surface is IP65F
*1
,
P67F
*1
or Type 1 Enclosure. When using a front USB cover (with screw
*2
) by Pro-face (Model
Number PFXZCDCVUS1), the front surface is IP66F
*1
, IP67F
*1
, Type 1, Type 4X (Indoor Use
Only) or Type 13 Enclosure.
Regardless of using a factory-installed front USB cover or a front USB cover with screw, when the
cover is open, the front surface is Type 1 Enclosure.
*1 IP65F, IP66F and IP67F are not part of the UL certification.
*2 The necessary torque is 0.5 N•m (4.4 lb-in).
CAUTION
RISK OF INJURY
When opening the Front USB Cover, be careful not to injure your fingers.
Failure to follow these instructions can result in injury or equipment damage.
Step Action
1 Place your finger or a tool (such as a screwdriver) in the gap on the top of the
front USB cover and pull down as illustrated.
NOTE:

When using the front USB cover by Pro-face (Model Number
PFXZCDCVUS1), loosen the top screw using a Phillips screwdriver.

The required torque is 0.5 N•m (4.4 lb-in).