Pro-face FP5000 Series, Руководство пользователя

Страница: 35 / 95

FP5000 Series User Manual
35
Structural Specifications
*1 The front face of this product, installed in a solid panel, has been tested using conditions
equivalent to the standards shown in the specification. Even though this product’s level of
resistance is equivalent to these standards, oils that should have no effect on this product can
possibly harm this product. This can occur in areas where either vaporized oils are present, or
where low viscosity cutting oils are allowed to adhere to this product for long periods of time. If this
product’s front face protection sheet peels off, these conditions can lead to the ingress of oil into
this product and separate protection measures are suggested.
Also, if non-approved oils are present, they may cause deformation or corrosion of the front panel’s
plastic cover. Therefore, prior to installing this product, be sure to confirm the type of conditions
that will be present in this product’s operating environment. If the installation gasket is used for a
long period of time, or if this product and its gasket are removed from the panel, the original level
of protection cannot be kept. To maintain the original protection level, be sure to replace the
installation gasket regularly.
*2 For dimensional tolerance, ever1/-0 mm (+0.04/-0 in) and R in angle are below R3
(R0.12 in).
*3 Even if the installation wall thickness is within the recommended range for the panel cut
dimensions, depending on wall’s material, size, and installation location of this product and other
devices, the installation wall could warp. To prevent warping, the installation surface may need to
be strengthened.
FP-5600TPD FP-5700TPD
Grounding
Functional grounding: Grounding resistance of 100

, 2 mm
2
(AWG 14) or thicker wire,
or your country’s applicable standard (same for FG and SG terminals).
Cooling method Natural air circulation
Structure
*1
When using a factory-installed front USB cover: IP65F
*
, IP67F
*
, Type 1
*
When using a front USB cover as an option: IP66F
*
, IP67F
*
, Type 1
*
, Type 4X (Indoor
Use Only)*/13
*
* On the front panel when properly installed in an enclosure and not using the front panel
USB port.
NOTE: The option is a front USB cover with screw by Pro-face (Model Number
PFXZCDCVUS1).
External
dimensions W315 x H241 x D67 mm
(W12.4 x H9.49 x D2.64 in) W397 x H296 x D67 mm
(W15.6 x H11.7 x D2.64 in)
Panel cut
dimensions W301.5 x H227.5 mm
(W11.87 x H8.96 in)
*2
Panel thickness area:
1.6...5 mm (0.06...0.2 in)
*3
W383.5 x H282.5 mm
(W15.1 x H11.12 in)
*2
Panel thickness area:
1.6...5 mm (0.06...0.2 in)
*3
Weight 3.9 kg (8.6 lb) or less 5.2 kg (11.5 lb) or less