20 / 34
3.2.
Preparation
Requirements for
receiving screen data
from GP3000 Series
*1
PC in which GP-Pro EX Transfer Tool is installed.
*2
USB Transfer Cable (model: CA3-USBCB-01)
* Possible to send/receive a screen via a CF card, a USB
storage device or Ethernet.
Requirements for
converting screen data
of GP3000 Series and
transferring the
converted data to
SP5000 series.
PC with GP-Pro EX installed.
*Ver4.02 or later is required for SP-5B10
*3
*Ver4.08.200 or later is required for SP-5B00.
Transfer Cable (The following three types of cables are
available)
・
A USB transfer cable (model: CA3-USBCB-01)
・
A USB data-transfer cable (model: ZC9USCBMB1)
・
A commercial USB cable (USB Type A/mini B)
* Possible to send/receive a screen via a SD card , a USB
storage device or Ethernet.
*1:
This step is required if screen data is saved only in the GP unit, not in any other device.
*2:
Please use the same version or later as or than that of the software used during creating screens on
GP3000 Series. If you don’t know the version, we recommend you to use the newest version. For the
newest version, you can download the transfer tool from our web site called [OtasukePro!]
http://www.pro-face.com/otasuke/download/freesoft/gpproex_transfer.htm
*3
PROFIBUS DP slave/MPI unit (Model number:PFXZCDEUPF1) of SP5000 series is supported at GP-Pro EX
V4.07.000 or later. Also FLEXNETWORK unit (Model number: PFXZCHEUFN1), CANopen Master unit
(Model number: PFXZCHEUCAM1) is supported at GP-Pro EX V4.07.200 or later
