Prinzen PSPC5, Руководство по обслуживанию, Страница: 31 / 73

INSTALLATION
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 31 of 73
CONNECTION EGG
COLLECTING CONVEYOR
47. A volt free contact is available for a start /
stop signal from the packer to the egg
collecting conveyor. Maximum contact load
permitted is 230Vac, 4 Amps.
Connect a cable from the egg collection
conveyor to connections 29 and 30 of
terminal X1 in the top center of the
electrical cabinet.
The volt free contact is controlled by relay
K10. When the contact is open, the egg-
collecting conveyor must stop. When the
contact is closed the egg-collecting
conveyor is allowed to supply eggs to the
packer.
48. Check the start and stop timers for the
egg-collecting conveyor. When the infeed
belt of the packer is full with eggs from the
egg-collecting conveyor the egg pressure
switches at the side of the infeed belt are
activated. When these switches remain
activated for a certain time (stop delay
time), a signal is sent to the egg-collecting
conveyor to stop supplying eggs. When the
switches are no longer activated, a certain
time later (start delay time) a signal is sent
to the egg-collecting conveyor to supply
eggs again.
Adjust the delay times to get a smooth flow
of eggs without too much starting and
stopping of the egg-collecting conveyor.
For adjustment of the timers see the user
manual.
49. Train operators of the system for
operation, cleaning and maintaining the
system as described in the user manual.
47
47