Prinzen PSPC5, Руководство по обслуживанию, Страница: 27 / 73

INSTALLATION
SM-PSPC5-01-E/12-2007 SERVICE MANAUL PSPC5 Page 27 of 73
POWER AND AIR SUPPLY
15. Connect the air to the air regulator
underneath the output conveyor.
16. Connect the main power to the main power
terminals in the left top corner of the
electrical cabinet. Connect the phase lines
to L1, L2 and L3. Connect the neutral to N
and the protective earth to PE. Measure
the voltages between all phases and
between all phases and the Neutral. Make
sure that the measured values correspond
with the machine tag.
ATTENTION!
Make sure the main power corresponds with
the voltage on the machine tag.
17. Switch on the main power switch.
18. Read the warning label attached to F3. Do
not remove it yet!
ATTENTION!
Make sure F3 and Q3 are OFF. When F3 and
Q3 are ON, starting the system may damage
the clutch of the denester. Follow below
installation procedure carefully to prevent this.
19. Press the start button once to reset the
system and press it a second time to start
it.
20. Check the running direction of infeed belt.
The direction must be towards the infeed
gates.
21. When the rotation direction of the infeed
conveyor is wrong, press the stop button
and switch off the system. Also switch off
the main power supply to the electrical
cabinet of the system and swap the 2 wires
L1 and L2 of the main power supply.
22. Check the running direction of the infeed
belt again and make sure it is running
towards the infeed gates now.
ATTENTION!
Make sure the infeed belt direction is correct.
When the infeed belt direction is correct, we
assume that the output conveyor direction is
also correct. Wrong running direction of the
output conveyor damages the clutch of the
denester.
15
16 17
18
19
21
21