Printronix SLPA7000e, Руководство по обучению и справочное руководство

Страница: 46 / 76

46
Chapter 4
Cleaning
Cleaning The Applicator Pad
Figure 16. The Applicator Pad Assembly
The applicator pad must be clean to ensure that labels will properly dispense.
Use isopropyl alcohol and a clean soft cloth. No other cleaning agent should
be used to clean the applicator pad.
Perform a maintenance check of the applicator pad vacuum chamber
approximately every three months, at minimum, using the following
procedures:
1. Remove the four (or six) hex screws found at the top of the applicator
pad, allowing the bottom pad to drop downward.
2. Check the holes of the applicator pad to make certain that there are no
large particles of dirt or dust clogging any of the holes.
3. Reassemble, making certain that the gasket (foam tape) is seated
properly before replacing the bottom pad.
4. Check for leaks by covering all the holes in the applicator pad with a piece
of paper. If there is a leak, the vacuum will not retain the paper on
underside of the applicator. Sealing compound may be used to isolate
leaks, but must dry thoroughly before the applicator may be used.
Hex Screw (4 or 6)
Top Pad
Gasket
Bottom Pad