MtP300 Quick Setup Instructions
Important:
1. You must charge the battery for at least 2½ hours prior to the first use.
2. Maximum battery capacity is first reached after completing three complete charge and discharge cycles.
3. Always
use
Genuine Printek Media to ensure optimal performance.
•
To load media:
•
Move the Paper Door Release in the direction indicated in Figure A and open the Paper Door.
•
Move the media support by pressing in the area indicated by the arrow in Figure B and place the roll between the
supports. Make sure the media rotates freely. Lay the leading edge of the media through the print head as shown in
Figure C, and close the door firmly.
•
To install the battery: Slide the battery into the battery compartment until the release lever on the battery snaps into place.
You may remove the battery by pressing the release lever toward the bottom of the printer and pulling the battery out of the
battery compartment.
•
To charge the battery, connect a PrintekMobile
™
power adapter (sold separately) to the appropriate power source and
plug the output cable into the printer’s Power Connector as shown in Figure A. The Battery Indicator will turn on indicating
that the battery is being charged.
•
To perform a self test, press and hold the Paper Feed Button while turning on the printer with the
Power Button.
Note: For more information, refer to the MtP300 Series Operator’s Manual. You may download this manual at www.printek.com.
Figure C
Battery
Release Lever
Serial I/O
Connector
Power
Connector
Paper Door
Tear Bar
Paper Door Release
Figure A
Power
Paper Feed
/Advance
Paper Supply Gauge
Figure B
Movable Media Support
Paper Leading Edge
Magnetic Card
Reader