Panther T14R - Operation and maintenance manual
ELECTRIC SYSTEM MAINTENANCE
148/178
REPLACING THE FUSE OF THE CAB HEATER
The fuse of the cab heater unit is located below the
electrical box of the cab.
To change the fuse, proceed as follows:
» If not already done, turn off the engine, remove the
key from the ignition switch;
» Turn off the battery isolator switch.
» Remove the cover of the cab electrical box.
» Remove the two bolts holding the plastic liner. Gen-
tly pull out the liner and identify the fuse to replace.
Figure 232
1. Plastic liner around the electrical box
2. Holding screws
» Extract the burned fuse and replace with one of an
identical type and rating.
Figure 233
1. Electrical box in the cab
2. Fuse of the cab heater unit
» Re-install the plastic liner.
» Re-install the electrical box cover.
» Turn on the battery isolator switch.
» Check function of the repaired circuit.
0274960066
2
2
1
0274960065
1
2
REPLACING A FUSE ON THE BATTERY SUP-
PORT
Figure 234
1. Starter relay
2. Power distribution module on the battery support
Figure 235
1. PETU fuse (30 A rating)
2. ECM fuse (30 A rating)
3. Cab fuse (200 A rating)
4. Glow plug fuse (80_A rating)
5. Starter fuse (80_A rating)
To change a fuse, proceed as follows:
NOTE : If changing both, replace them one at a time.
» If not already done, turn off the engine, remove the
key from the ignition switch;
» Turn off the battery isolator switch. Gain access to
the fuse.
» Raise the protective cap and remove the nuts
retaining the fuse to replace.
Work only on one
fuse at a time.
» Extract the burned fuse and replace with one of an
identical type and rating.
CAUTION
Fire hazard
Never invert fuse position. Fuse ratings are very
different and cannot be interchanged.
0275490016
2
1
0275490017
1
4
5
3
2