INSTALL ANALOG CLOCK: WALL MOUNT
The backs of most analog clocks feature two specially designed clock-lock hangers spaced at precise distances, one
on the top and the other on the bottom. The clock-lock feature prevents accidental removal if the clock is bumped and
it may reduce theft by requiring a particular combination of moves to remove the clock. To avoid the clock-lock
feature, use finishing nails with no heads angled at 45 degrees into the wall in place of headed screws.
Supplied components
Quantity
Component
2
Screw, #8 x 1 1/4” flat head
2
Anchor
Wall mount with clock-lock hanger
1. Verify the installation requirements are met.
2. Drill holes for the screw anchors at the spacing listed in the following table. If two screws are being used to
secure the clock to the wall using the clock-lock mount, the distance between the screws is precisely the same as
the hole spacing specified below.
Model
Hole Spacing
Mounting Type
12.5" Round Model*
9 in. (22.86 cm)
Clock Lock (2)
16" Round Model
9 in. (22.86 cm)
Clock Lock (2)
3. Use a screwdriver to insert and tighten each screw, leaving the top of the screw head 3/8 in. (0.9 cm) out from the
wall.
4. Apply power to the clock.
Page 6
