22
Figure 5.1 Stripped length (unit: mm)
Step 2 : Insert the exposed core wires into the crimping areas of the OT terminal and
crimp them using hydraulic pliers, as shown in Figure 5.2.
Figure 5.2 Crimping a cable (unit: mm)
Step 3 : Remove the ground screws from the ground points, as shown in Figure 5.3.
Figure 5.3 Remove the ground screws
Step 4 : Secure the PGND cable (done by step 1 & 2) using the ground screw and
tighten the screw to a torque of 1.2 N.m using a socket wrench, as shown in Figure 5.4.
Figure 5.4 Secure the PGND cable
5.2
Connecting AC Output Cables
【
Preparation
】
The AC power cable and AC terminals have been prepared. Outdoor copper-core cables are
recommended for AC power cable. Table 5.1 describes the specifications.
L3<2mm
L4<(0~1.5)mm