Primes Cube L1, Оригинальное руководство пользователя

Страница: 8 / 56

35,0(6
Cube L1
8
Revision 03 EN - 03/2021
1 Basic safety instructions
Intended use
The device has been designed exclusively for measurements in the beam of high-power
lasers.
Use for any other purpose is considered as not intended and is strictly prohibited.
Furthermore, intended use requires that you observe all information, instructions, safety
notes and warning messages in this operating manual. The specifications given in chap-
ter 19, „Technical data“, on page 52 apply. Any given limit values must be complied
with.
If not used as intended, the device or the system in which the device is installed can be
damaged or destroyed. In addition, there is an increased risk to health and life. Only use
the device in such a way that there is no risk of injury.
If you still have questions after reading this operating manual, please contact PRIMES or
your supplier for your own safety.
Observing applicable safety regulations
Observe the safety-relevant laws, guidelines, standards and regulations in the current
editions published by the state, standardization organizations, professional associations,
etc. In particular, observe the regulations on laser safety and comply with their require-
ments.
Necessary safety measures
The device measures direct laser radiation, but does not emit any radiation itself. How-
ever, during the measurement the laser beam is directed at the device. This produces
scattered or directed reflection of the laser beam (laser class 4). The reflected beam is
usually not visible.
Protect yourself from direct and reflected laser radiation while working with the device
by taking the following measures:
•
If the device is moved from its aligned position, increased scattered or directed
reflection of the laser beam occurs during measuring operation. Fix the device in
such a way that it cannot be moved by unintentional bumping or pulling on the
cables.
• Connect the laser control’s safety interlock to the device. Check that the safety
interlock will switch off the laser properly in case of error.