Primes BeamMonitor BM+ 100S, Оригинальное руководство пользователя

Страница: 43 / 68

BeamMonitor BM+
35,0(6
43 Revision 02 EN - 02/2022
Option Explanation
Window size in mm If the autom. Measurement window option is disabled, the size of the
measurement window can be set manually. Use one of the following
options:
X
Enter the length and width in the corresponding fields.
X
Position the mouse pointer anywhere within the measurement
range and drag while holding down the left mouse button. Keep the
mouse button pressed until the measurement window meets your
requirements.
Position in mm Use one of the following options to adjust the position of the measure-
ment window:
X Enter the x-position / y-position in the corresponding fields.
X Position the mouse pointer within the measurement window. Then
drag while holding down the right mouse button.
Gain in dB
The option can be used to control the sensitivity of the detector.
Use one of the following options:
X
Enter a value in the input field.
X
Use the slider below the input field.
Find beam This option enables an automatic beam search with an automated mea-
suring window size and measurement. The laser beam is automatically
searched for in the entire measuring range. Measurement window size
and gain are set automatically.
The measured plane is then displayed in the graphic display.
X Click on the button to start the beam search.
Note that the determined measurement data will not be saved in the
project tree of the Projects tab.
Parameter settings All settings in the Device control menu can be individually saved for
each device. The saving location is the local installation of the LDS.
These and other options for saving / loading configurations are de-
scribed in chapter 9.3.5 „Saving options“ on page 30.
Save current parameters X
Click this button to save all current settings of the connected de-
vice.
Load last parameters X Click this button to load the last saved device configuration.
Tab. 9.3: Options in the Device control > Settings tab of the Monitor measuring mode