PRIMERGY BX620 S3, Руководство пользователя

Страница: 189 / 287

189
PRIMERGY BX620 S3 Server Blade User’s Guide
1
7
Inst
a
llin
g I
n
te
rn
al O
p
tions
8
Install the server blade to the chassis.
→
"4.2 Installing Server Blades" in "BX600 S2 Blade Server System Unit Hardware Guide"
7.4.4 Defective Memory Disconnection Function
This server blade is equipped with the defective memory (RAM module) disconnection function.
This function disconnects memory blocks (two DIMMs) judged to be defective (abnormal) during
Power On Self Test (POST) to start the server blade. When POST is executed, if the memory capacity is
discovered to be smaller than the capacity of the memory installed, there is a possibility of memory
defect.
From POST error messages or the system event log, you can check the slot location that has defective
memory.
"9.2.2 Error Messages" (pg.246)
"9.3 System Event Log" (pg.258)
If defective memory is discovered, replace it, and then restart the server blade.
■
Replacing the Defective Memory
Replace the defective memory with a new one according to "7.4.3 How to Install/Remove Memory
Module" ( pg.188).
After replacing the memory module, start the BIOS Setup Utility and select the [Server] menu - the
[Memory Status] submenu to check that [DIMM n,n] (n is the number of the replaced memory module)
for the replaced memory module is set to [Enabled]. If the item is set to [Disabled], change the setting
to [Enabled]. If it is not set to [Enabled], the server will start with the memory module recognized as
being defective and constantly disconnected.
To use a new memory module, set the item to [Enabled] for releasing the failed memory status at the
next startup.
"8.2.11 Memory Status Submenu" (pg.222)