PRIMERGY BX600 S3, Руководство по оборудованию

Страница: 98 / 143

98
Chapter 5 CLI
❑
: Parameter
Parameter Setting Contents
1. Server power
❑
Power On
❑
graceful
shutdown and off
❑
graceful
shutdown and
power-cycle
❑
hard reset
❑
NMI
❑
Hard Power off
Sets Server Blade power supply.
When using, refer to "6.2 Points to Note about Remote
Power OFF and the Shutdown Function" ( p.139).
• Power On
Turns the server on.
• graceful shutdown and off
Turns off power after shutting down the OS using the
ServerView agent operating on the Server Blade.
• graceful shutdown and power-cycle
Turns power on again after turning off power and
shutting down the OS using the ServerView agent
operating on the Server Blade.
• hard reset
Reboots the Server Blade.
• NMI
Do not normally select.
• Hard Power off
The Server Blade is forcibly turned OFF.
Important:
When using this function, it is necessary to make various settings to
Server Blades. For details, refer to "6.2 Points to Note about
Remote Power OFF and the Shutdown Function" (
p.139). Do not
select when performing operations for Server Blades that are not
supported because there is a fear that unexpected operations such
as ACPI shutdown or power off may occur.
Remarks:
When ordering power on after ordering Server Blade power off,
check the power has been turned off correctly.
2. Set Server Maximum Restart
Retries
❑
0
–
7 Sets how many times will be retried after OS start fails.
If set to 0, retry will not be performed.
3. Set Server Boot Mode
❑
normal
❑
pxe-lan-1
❑
pxe-lan-2
❑
pxe-lan-3
❑
pxe-lan-4
❑
pxe-lan-5
❑
pxe-lan-6
❑
add-in-pci-lan-1
❑
add-in-pci-lan-2
Sets the boot method for Server Blade OS boot.
• normal
Sets the boot order of Server Blade to the default
settings set in BIOS.
• pxe-lan-1 – pxe-lan-6
Set the selected LAN port to the top priority of the
Server Blade boot order and change so that it boots in
Preboot eXecution Environment (PXE).
• add-in-pci-lan-1 / add-in-pci-lan-2
Set LAN port 1 or 2 installed in the expansion card
slot module to the top priority of the Server Blade boot
order and change so that it Preboot eXecution
Environment (PXE).
Note:
When installing expansion cards other than a LAN card, if "add-
inpci-lan-1" or "add-in-pci-lan-2" is selected the Server Blade will
stop in the middle of boot. If this happens, turn off the Server Blade,
change the boot mode and then turn the power on again.