PRIMERGY BX600 S3, Руководство по оборудованию

Страница: 73 / 143

73
PRIMERGY BX600 Management Blade Hardware Guide
●
12. Agent HTTP (1_1_12)
Sets the HTTP agents in the Management Blade.
❑
: Parameter
Parameter Setting Contents
1. Set HTTP Enable
❑
enable
❑
disable
Sets HTTP service enable/disable. Settings become valid
after restarting the Management Blade.
If HTTP service is disabled Web UI cannot be used.
2. Set HTTP Port - Sets the port number of HTTP. These setting become valid
in 10 seconds.
3. Set HTTP SSL Enable
❑
enable
❑
disable
Sets whether HTTP SSL is to be used.
Important:
In order to use SSL, it is necessary to enable SSL version 3 only in the
Web browser. Also, if SSL version 2 is enabled in the Web browser,
change to disable.
4. HTTP IP Filter Table - Performs IP settings that permit HTTP connection. A
maximum of 10 IPs that permit HTTP can be registered.
"255.255.255.255" is registered by default so it will not
perform IP filtering. It must be deleted as necessary when
performing IP filtering.
+------------------------------------------+
| |
+------------------------------------------+
Agent HTTP page_1_1_12
(1) Set HTTP Enable : enable
(2) Set HTTP Port : 80
(3) Set HTTP SSL Enable : disable
(4) HTTP IP Filter Table
Enter selection or type (0) to quit: