PRIMERGY BladeFrame BF200, Инструкция по первоначальной настройке

Страница: 48 / 115

Initial Setup Guide cBlade ES
3-10 Release 5.0
Figure 3.6 Mounting the side rails into the rack
10. Secure the front of the left rail to the left support upright using
two M4x10 centering screws.
11. Secure the back of the left rail to the support bracket using two
M4x10 centering screws.
12. Repeat the steps with the right rail (to be mounted on the right
support uprights).
Note: If you are installing more than one BladeFrame BF200 in
your rack, leave a 1U gap between each chassis (see Figure 3.7).
This allows for the subsequent installation of redundant power
supplies. For more detail on installing redundant power
supplies, see Chapter 4,
Connecting the BladeFrame to a Power
Source .
The redundant power option is not available with systems sold
outside of North America.