P r i m a L u c e L a b S . p . A .
E A G L E C O R E U s e r M a n u a l
Quick guide
For EAGLE CORE operation, it is essential to correctly set the DSLR or mirrorless camera, the equatorial mount
and the autoguide camera. This table summarizes what needs to be set, please read the following paragraphs of
this manual before using EAGLE CORE with your telescope.
Scope of delivery and parts identifications
1) EAGLE CORE control unit
2)
12V power cable with cigarette plug for Eagle (length 110cm)
3)
4 M6x12 screws, 4 M6x8 screws
4) Quick guide
The numbers indicate the name of the component listed below. Read the following paragraphs for details on
operation.
DEVICE:
HOW TO SET:
DSLR or mirrorless camera:
- M (or B if present) mode.
- Manual focus if you use a telephoto lens instead of a telescope.
- used with a free memory card (we suggest to format the memory
card before use with EAGLE CORE).
- set without auto noise removal (auto dark).
- set without mirror lock up.
- set without automatic rotation of the image
Equatorial mount:
- Corrected aligned to the Pole.
- Aligned to the stars and with automatic tracking active.
- Correct weight balance.
Autoguide system:
- Autoguide camera connected to ST4 port of the mount.
Power system:
- Battery 12V fully charged and with sufficient capacity to power the
entire telescope for many hours or power supply.
page 4
1) Wi-Fi antenna
2) N°2 USB 2.0 ports
3) Ethernet port
4) N°1 USB 2.0 port
5) 12V 3A power out port
6) 12V 3A power out port
7) 12V 5A power out port
8) 12V power in port
9) “PW” LED signal
10) “ACT” LED signal
11) “RST” reset button
12) “WIFI” button
Image 1
