BUILT-IN GAS HOB
INSTALLATION AND USER INSTRUCTIONS
Note: Do not use the hob until you have read the instruction manual.
Cod:
1. INTRODUCTION
(*) Air inlet minimum section: 100cm
2
Fig. 1 Fig. 2 Fig. 3
UNPACKING THE APPLIANCE
Remove all packaging and make sure the appliance is in perfect condition.
If you have any doubts, do not use the appliance and call your supplier..
Some parts on the appliance are protected by a plastic film. This protective film must be removed
before the appliance is used.
1
2
3
Even if you have used a gas hob before, it is important that you read these instructions thoroughly
before using the appliance, paying particular attention to the installation and safety instructions. If you
have any problems installing, operating or cooking with your hob, please check through these
instructions to ensure all of them have been adhered to.
WARNING! For your own safety, make sure that these instructions on installation, use and
maintenance are followed.
Please keep these instructions in a safe place for future reference.
Should the appliance be sold or transferred, please pass on these instructions to the new owner
.
2. YOUR HOB
3. CLEANING
Applicable for Gas
CAST IRON OR ENAMELLED PARTS
In order to clean the hotplate, burner caps and pan supports on your hob, please use a soft cloth and hot,
soapy water.
Stubborn stains can be removed with a non-abrasive cleaning agent, so as not to damage the enamel
surface.
NOTE:
The enamelled
pan supports can also be cleaned safely in the dishwasher.
STAINLESS STEEL
To clean the hotplate surface, clean with a cloth soaked in hot, soapy water and then dry with a soft cloth to
avoid scratching.
PLASTIC
To clean the control knobs, wipe clean with a damp, soapy cloth.
GLASS
A non-abrasive cleaner should be used on glass surfaces.
Any abrasive cleaner (including Cif) will scratch the surface and could erase the control panel markings.
Glass can be effectively cleaned by simply using a dilute solution of water and mild detergent and drying to
a shine with a clean cloth.
4. SAFETY INSTRUCTIONS
Make sure that this instruction booklet is read thoroughly and understood before attempting to install or
operate this hob.
The instructions are provided in the interest of your safety.
GAS SAFETY REGULATIONS AND USE OF YOUR HOB
1. It is a legal requirement that all gas appliances are installed by qualified personnel only in accordance
with current legislation. It is your responsibility to ensure compliance with the law.
2. Repairs or servicing of this product must only be carried out by an authorised service agent using
approved parts.
3. No attempt must be made to modify this appliance under any circumstances.
4. Cooking appliances can become very hot in use – please keep children and pets away from them.
5. Do not allow children to operate or play with any part of the appliance.
6. Do not use unstable pans and ensure that the handle is positioned away from the edge of the worktop.
7. In the interest of hygiene and safety, please ensure the hob is kept clean.
8. This appliance is designed for domestic cooking only. Commercial use will invalidate the warranty.
9. Do not cover the hob or place combustible materials on or near the surface even when the hob is not
in use.
10. Do not fill deep fat frying containers more than one third full of oil and NEVER leave unattended.
11. Before cleaning the hob, switch off at the mains.
12. When cooking is finished, switch off all controls and allow to cool.
13. These appliances are not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervi-
sion or instruction concerning use of the appliance by a person responsible for their safety.
14. If the supply cable is damaged, it must be replaced by the authorised service agent or qualified person
only.
15. Do not immerse the appliance or the power cable into water or any other liquid.
5. INSTALLATION INSTRUCTIONS
TECHNICAL INFORMATION
The installation, adjustments, conversions and maintenance listed in this section must be carried out by
qualified personnel only.
The safety and automatic adjustment devices of the appliance may only be modified by an authorised
service agent.
The installation of this gas hob must comply with UK standards.
This appliance must be fitted in compliance with the installation rules given above. Also, particular attention
must be given to the following requirements for ventilation.
WARNING!
a) Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure)
and the adjustment of the appliance are comptaible;
b) The adjustment conditions for this appliance are tated on the label(or data plate);
c) This appliance is not connected to a combustion products evacuation device, It shall be installed and
connectd in accordance with current installation regulations. Particular attention shall be given to the
relevant requirements regarding ventilation
INSTALLATION LOCATION
The appliance may be located in a kitchen, kitchen/diner or utility room, however, it cannot be in a room
containing a bath or shower. The hob must not be installed in a bed-sitting room of less than 20m
3
.
LPG models must never be installed in a room or internal space below ground level, i.e. in a basement.
PROVISION FOR VENTILATION
The room containing the appliance should have an air supply in accordance with BS5440: Part 2.
The room must have an opening window or equivalent, some rooms may also require a permanent vent.
If the room has a volume between 5-10m
3
, it will require an air vent of 50cm
2
effective area, unless it
has a door which opens directly to the outside. If the room has a volume of less than 5m
3
, it will require
an air vent of 100cm
2
effective area (Fig. 1). If there are other fuel burning appliances in the same room,
BS5440: Part 2 should be consulted to determine air vent requirements.
NOTE:
The use of a gas cooking appliance results in the production of heat and moisture in the room in
which it is installed. Always ensure that the kitchen is well ventilated; keep natural ventilation holes open
or install a mechanical ventilation device (fig 2).
When using more than one hotplate at once, open a window if a mechanical extractor is not present or
working (Fig. 3).
The packaging materials should be carefully discarded and not left within easy reach of children as they
are a potential hazard.
INSTALLING AND FIXING THE HOB (QUALIFIED PERSONNEL ONLY)
The appliance can be fitted to any worktop with a thickness of 40mm or 50mm.
No overhanging surface or cooker hood should be closer to the hob than 750mm.
Fix the appliance in position (Fig. 4). The sides of the adjacent cabinets above may be lower than
750mm down to 334mm, provided they are heat and steam resistant.
These hobs are supplied with a special seal which prevents liquids from seeping underneath the
appliance. Follow these instructions in order to correctly fit this seal:
Rapid
gas
burner
Semi-rapid
gas
burner
burner
Auxiliary
gas
Material
Flame
failure
device
Power
Supply
Size
(mm)
Built-in
(mm)
Type
500x580x100
510x700x100
Yes
Triple flame
gas burner
477x557
3
.
8kW
3.0kW
1.75kW
1.0kW
AC 220-
240V
50/60HZ
AC 220-
240V
50/60HZ
Yes
477x557
Glass
Glass
3
.
8kW
/
1.75kW
1.0kW
PRGH212
PRGH212
PRGH212
PRGH214
PRGH214
PRGH214
Semi-rapid
gas burner
1750W
1750W
Semi-rapid
gas burner
1750W
Auxiliary
gas burner
1000W
Auxiliary
gas burner
1000W
Rapid
gas burner
3000W
Triple flame gas burner 3800W
Triple flame
gas burner
3800W
Semi-rapid
gas burner
1750W
Semi-rapid
gas burner
