Pride Euro Seat 2, Основные инструкции по эксплуатации

Страница: 9 / 28

Basic Operation Instructions 9
www.pridemobility.com Euro Seat 2
COMFORT ADJUSTMENTS
There are several adjustments that can be made to the Euro Seat 2 to increase
your comfort, such as seat height and angle, armrest position, and controller
position.
WARNING! The center of gravity of your seating system was
factory set to a position that meets the needs of the
demographic majority of users. Your authorized Pride Provider
has evaluated your seating system and made any necessary
adjustments to suit your specific requirements. Do not change
your seating configuration without first contacting Pride
Mobility Products or your authorized Pride Provider.
WARNING! Some power chair components are heavy. You
may need assistance to lift or carry them. Please refer to
the specifications table for specific component weights
before you disassemble the power chair.
WARNING! Remove the occupant from the power chair
before making any adjustments.
WARNING! Be sure that the controller’s power is turned off
and the power chair is not in freewheel mode before
performing any adjustment procedures.
You may need the following to make comfort adjustments:
„ metric/standard socket set and ratchet
„ adjustable wrench
„ metric/standard hex key set
Seat Height and Angle Adjustment
The Euro Seat 2 is usually connected to a power base with four steel towers.
You can change the seat height by raising these towers. If you raise or lower
only one set of seat towers (front or rear), you can also change the seat base
angle.
To change the seat height or seat angle:
1. Remove the retaining pin from each of the four seat mount connectors.
See figure 2.
2. Raise or lower each seat tower to the desired position. To change the
angle, set either the front or rear seat towers higher or lower than the
other.
3. Reinstall the retaining pin into each seat mount connector.