24
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and
can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has
been turned off, then turned back on.
BEEP CODE
CONDITION
SOLUTION
(1)
Battery charge is low.
Charge batteries as soon as
possible.
(2)
Battery charge is too low.
Charge batteries.
(3)
The scooter’s battery voltage is
too high to operate the scooter,
or the charger is still connected to
the offboard charger port.
Unplug charger and/or turn key off,
then back on again.
(4)
Current limit time out.
Turn the scooter off for a few
minutes, then turn your scooter
back on.
(5)
The manual freewheel lever is in
the freewheel (forward) position.
Remove the key from the key switch,
then push the manual freewheel
lever to the drive (rearward)
position, and restart your scooter.
(6)
Throttle control lever not at center
position at start up.
Return the throttle control lever to
centre position, turn scooter off
then back on.
(7)
Speed pot or throttle control error. Contact your authorised Pride
Provider for assistance.
(8)
Motor volts error.
Contact your authorised Pride
Provider for assistance.
(9)
Other internal errors.
Contact your authorised Pride
Provider for assistance.
V I I I . B A S I C T R O U B L E S H O O T I N G
Содержание CELEBRITY DELUXE
Страница 1: ...CELEBRITY DELUXE OWNER S MANUAL OPERATION COMFORT MAINTENANCE BATTERY CHARGING...
Страница 31: ......
