background image

Page  1 of 8

Model  CDMD   

I&O IN-159

Installation,
Operating,
and
Maintenance
Manual

CD Mag Drive

Caution:
Before installing,
repairing or performing
maintenance on this
pump, read these
instructions completely.

      Photo is pasted on
      Need iacdmd.dxf
      from engineering

Installation

Electrical

WARNING!
Ground motor before
connecting to electrical
power supply!  Failure to
ground motor can cause
severe or fatal electrical
shock hazard!

Do not ground to gas
supply line!

Disconnect power to
motor before working
on motor or pump!

Match voltage to
nameplate voltage on
motor.  Incorrect voltage
can cause fire or
seriously damage motor,
voiding warranty.

                    Form IN-159

Close Coupled -  Motor Pumps

These pumps require no
special care in mounting,
although it is suggested that
they be firmly bolted to a level
surface.  Adequate air
movement over motor will
help prevent overloads.

Base Mounted Pumps
(Pedestal Pumps)

These pumps must be mounted
on a rigid steel base that will
not warp or flex.  Each pump
must be mounted such that 

the

pump shaft centerline is on
center with the driver shaft
centerline.  

Pads and/or shims

will be required on either
pump, driver or both.  The two
shafts should not touch each
other and the distance between
them depends on the coupling
used to connect them.

Misalignment will cause
bearing failure and void
warranty.  

Pumps are rough

aligned at the factory but must
be realigned after shipment
and installation.  Pulley driven
pumps must have pulleys in
line and good belt tightness
practices followed.

Direction of Rotation

Note: Motor shaft rotation is
viewed from the suction end of
pump.  A rotational arrow is
shown on the front of the
pump volute casing.  Incorrect
rotation can cause pump
damage, failure or reduced

Содержание CD Mag Drive









Отзывы: