128-7853
8 of 16
8
Brown Wire:
Negative Door Trigger
If the vehicle's door courtesy light switches ground when the door is opened, (Most GMs and
Imports), you must connect this wire to the negative output from one of the vehicle's door pin
switches. In most cases the Brown wire will need to be connected to only one door switch no
matter how many doors the vehicle has as most door lighting circuits are wired in parallel. This
wire will be shunted when remote starting the vehicle and will remain shunted, if active, while
running under command of the remote start. If this wire is active when the system is armed, the
siren will emit three chirps. When the zone clears, the siren will emit 1 chirp to confirm full
arming.
Note
for vehicles with interior delay lighting see programming under title "Completing The
Installation".
Dark Blue/Black Trace Wire:
External Trigger Input
The Dark Blue/Black trace wire allows the remote start unit to be activated from an external
source. The intent of this wire is to allow the unit to be controlled from a Telematic Paging
system or similar device. When this wire receives a ground pulse, the unit will start the vehicle.
Connect this wire to a ground pulsed output from the controlling circuit.
Purple Wire:
(+) Door Trigger Input
If the vehicle's door courtesy light sw 12 volts when the door is opened, (Some Fords
and some Imports), you must connect this wire to the positive output from one of the vehicle's
door pin switches. In most cases, the Purple wire will need to be connected to only one door
switch no matter how many doors the vehicle has as most door lighting circuits are wired in
parallel. This wire will be shunted when remote starting the vehicle and will remain shunted, if
active, while running under command of the remote start. If this wire is active when the system
is armed, the siren will emit three chirps. When the zone clears, the siren will emit 1 chirp to
confirm full arming. See below for wiring details.
Note for vehicles with interior delay lighting see programming under title "Completing The
Installation".
Orange/Black Wire:
Parking Brake Input
This wire is used only when the turbo timer mode, Bank 3, feature # 16 is selected ON. This input
insures that the vehicle parking brake is applied whenever the vehicle is set up for and the turbo
timer circuit is used. This input must switch to ground when the vehicle's parking brake is applied.
Connect the Orange/Black wire to the negative output of the vehicle's parking brake switch.
Dark Green Wire:
(-) Instant Trigger Input
This is the instant on ground trigger input wire. This wire must be connected to the hood and
trunk pin switches previously installed.
NOTE:
This wire will be shunted when remote control channel 3 is accessed, (trunk release).
This wire will remain shunted all the while there is ground present and for 5 seconds after the
ground is removed. This allows the operator to open the trunk via the remote transmitter without
having to first disarm the alarm system.
Black Wire:
Chassis Ground Source
Connect the Black wire to a known vehicle ground source or to a solid clean metal part of the
chassis. Be certain to remove any paint or grease and secure this wire with a self tapping
screw and ring terminal.
