Prestige medical Pouch Sealer, Инструкция по эксплуатации

Страница: 10 / 16

Page 10
www.prestigemedical.co.uk
sales@prestigemedical.co.uk
3: OPERATION
SETUP
To setup the pouch sealer plug the power cord into the power socket ensuring
the ON/OFF switch is in the OFF position while you do this. Remove the roll
holder from the unit by sliding it away from the user. Insert one or more rolls onto
the roll holder and reinsert the holder back into its housing.
Press the ON/OFF switch to the ON position, the LED will then turn green and
begin to flash. The heating element will now begin to heat up. Once the LED
stops flashing after approximately 3 – 4 minutes the pouch sealer will emit a peep
and the heating element will be at its
required temperature; the pouch sealer is
now ready for use.
Please Note - If the lever is activated before
the pouch sealer has reached the required
temperature, the LED will turn red and the
buzzer will sound. To prevent this return
the lever to the down position and wait
until the pouch sealer has reached optimum temperature.
SEALING
Unroll and insert the polypropylene pouch material into the rear slot of the front
tray, check that the clear plastic film is face up. Pull enough of the pouch material
through to fully cover the instruments that are going to be sealed. Close the
sealing bar by pulling the lever to the vertical position. Manually operate the
cutting tool by moving the slider from one side to the other (Making sure the
sheet has fully sealed before cutting).