Page
3
of
12
Introduction
Foremost we congratulate you on your purchase of a PRESSCON ExitOxy degasser system. This manual describes how
to install a PRESSCON ExitOxy degasser system. If there, despite our explanation in this manual, is a lack of clarity with
regard to the installation or if there are any questions in another way, don’t hesitate to contact us through the information
below.
Veilingweg 27 A
2675 BR Honselersdijk
Tel:
Web:
E-mail:
+31 (0) 174 648 300
Description of the hazard symbols
Symbol
Description
Symbol
Description
1. OVERPRESSURE VALVE,
Be aware of the sudden relief of
overpressure.
7. HIGH PRESSURE,
Relief pressure from components before
work is conducted.
2. DANGEROUS VOLTAGE,
Forbidden to work on the system if the
power is on.
8. HOT PARTS,
Do not touch parts with bare hands. Use
heat-resistant clothing.
3. DANGEROUS TO INHALE GAS,
Avoid the specified area or wear
appropriate breathing equipment.
9. MOVING PARTS,
Risk of getting stuck or injuries to limbs.
Turn the machine off completely before
working on it.
4. NOISE,
Wear ear protection to prevent hearing
damage.
10. ROTATING FAN,
Risk of getting stuck or injuries to limbs.
Turn the machine off completely before
working on it.
5.MACHINE WITH AUTOMATIC START,
Machine stops and starts automatically
when it is operating normally. Turn off the
machine completely before working on it.
11. ATTENTION,
Special situation occurs, follow additional
instructions.
6. READ THE OPERATING AND
MAINTENANCE INSTRUCTIONS,
It is advised that the maintenance
instructions are read before continuing
work.
