Part No.
Description
Qty.
652-017
45deg Contour Seat
3
652-026
45 deg Arc Support Frame
Direct Bury
1
516-058
3/8” X 1-1/2” SS Hex Bolt
18
516-028
3/8” SS Nylock Nut
18
516-023
3/8” SS Washer
36
938-45D-2
1 Position the support frame in the desired location and mark ground where holes need to be
drilled.
2 Drill plastic out of the mounting holes on the seats and stand using a 7/16” dia. drill bit.
3 Fasten the seats to the stand loosely.
4 Make sure that the three seats are level with each other and tighten all of the bolts.
5 Support the seats and frame at the desired height in the holes.
6 Fill holes with concrete and crown the top so that water will run off. Let stand for at least 24
hours before removing supports.
Periodic check of bolt tightness recommended.
72
3
8
28
11
16
18
1
2
12
In Accordance to California law: WARNING This product contains a chemical know to the State of California
to cause cancer and birth defects or other reproductive harm.
