MINI PAK’R V3
- MM2I2IN115 / MM2I2IN230
Page - 17 - of 21
Display codes
Display
code
Explanation
RDY
The machine is ready for air cushion production.
SLP
After 90 minutes without operation the machine enters in sleep mode to safe
power.
No actions needed.
STY
Machine is in reduced temperature mode.
No actions needed.
Error codes
If the Display shows an Error Code, and the red LED flashes, consult the chart below to
determine the cause. Clear the problem as described below, then press the
STOP/RESET
Button
to resume normal operation.
Display
code
Error
Action
E1
Cover open
Make sure covers are closed.
E2
Jam / end of roll
In case of jam, open cover and remove jammed film
carefully.
E3
Heater high temp.
issue
Contact Pregis for assistance and swap the machine.
E4
Heater low temp.
issue
Contact Pregis for assistance and swap the machine.
E5
Heating fault
Contact Pregis for assistance and swap the machine.
E6
No RFID tag
detected
Swap the film roll and reset the system. If error repeats,
contact Pregis for assistance and swap the machine.
E8
Temp. read fault
Contact Pregis for assistance and swap the machine.
E9
Incompatible tag
detected
Swap roll with compatible film roll. If the error still appears,
contact Pregis for assistance and swap the machine.
E10
Temp. read fault
Clear error and allow machine to reheat. If error repeats,
cycle power. If error repeats, contact Pregis for assistance
and swap the machine.
E11
Temp. read fault
Clear error and allow machine to reheat. If error repeats,
cycle power. If error repeats, contact Pregis for assistance
and swap the machine.
E12
Thermocouple
fault
Reset power to the machine. If error persists, contact
Pregis for assistance and swap the machine.
E16
Power monitor
fault
Contact Pregis for assistance and swap the machine.
E17
Power monitor
fault
Contact Pregis for assistance and swap the machine.