35
Step 84 Tail Pushrod Guides
Once the pushrod has cured, the servo position can be
fine tuned by moving the servo mount, generally position
the pitch plate assembly centered between the tail hub
and the tail gearbox. The instructions included with the
gyro will have specific instructions for the tail setup.
Insert two cable tie wraps in the rudder pushrod guides
and snug them up. Disconnect the ball link from the
rudder servo horn and adjust the guides and the angle of
the rudder servo to get the smoothest movement. Once
all binding has been removed tighten the cable ties with
pliers and trim the excess. Remember to tighten the
M2.5x12 socket cap screws in the rudder mount.
#HI6106 Pushrod
Guides x 2
#HI6106 Cable
Ties x 2
Step 85 Vertical Tail Fin
Holding the vertical fin (plastic or carbon) insert two M3x35 socket cap screw through the rear holes and two M3x45 socket
cap screws into the forward holes. Slide one spacer onto each screws and finally slide the vertical fin mount half (thinner
than the horizontal mount) onto the forward screws.
#HI6067 Verti-
cal Tail Fin
#HI6067
M3x5x6 Steel
Spacers x 4
M3x35 Socket
Cap Screws x 2
M3x45 Socket
Cap Screws x 2
#HI6068 Verti-
cal Fin Mount
Half (thin)
#HI6067A
Carbon Vertical
Tail Fin
Gas SE only
Step 86 Vertical Tail Fin Mounting
Holding the vertical fin (plastic or carbon) from the previ
-
ous step and position the fin on the left side of the tail boom.
Insert the M3x35 rear screws through the mounts in the tail
gearbox and slide the matching vertical fin mount over the
front screws to capture the tail boom. Secure in place using
four M3 locknuts.
M3 Locknut x 4
#HI6068 Verti-
cal Fin Mount
Half x 2
Be carefull when tightening the four screws
on the carbon tail fin. This fin has a hollow
section and can be damaged if the screws are
overtightened.
Carbon or Plastic
Tail Fin
