Precor Experience 700 line Series, Руководство по обслуживанию

Страница: 25 / 232

l
BELT SPEED TEST: Select SYSTEM TESTS > BELT TEST and follow
prompts to run test
l
HEART RATE TEST: Select HEART RATE TEST and follow prompts to run
test
2. Exit Hardware validation Test: On P10, P20, and P30 consoles press the RESET key
to exit diagnostics. On P62, P80, and P82 consoles press Back to exit diagnostic and
return to the Home page.
Operational Tests
1. Select QUICKSTART to begin a manual program and operate the treadmill at least 5
minutes. While walking on the unit perform the following tests:
2. Operate the SPEED and INCLINE controls from minimum to maximum ranges while
verifying the operation.
l
Make sure that the operation is smooth and that there are no unusual noises.
l
Also verify that the console parameter indicators and user interface displays are
showing correct information.
3. While walking on the treadmill, press the STOP button and verify that the running belt
slows to a stop.
4. Continue the QUICKSTART program. While walking on the treadmill, pull the ESTOP
lanyard and make sure the running belt slows to a stop.
Running Belt Tracking
1. Step off the treadmill and operate the treadmill at 12 mph (19 kph) for one minute. Verify
that the running belt remains centered, see "Running belt tracking adjustment" on
page 47 if adjustment is necessary.
Return to service
1. Switch the power OFF.
2. Make sure that the treadmill is setting level and stable, adjust the two rear leveling feet
as necessary.
3. On successful completion of these tests, return the treadmill to service.
Page 17
2 Operation Verification
Operation Verification Tests.